View Full Version : Focus SVT Fuelpump in SN95 install

09-22-2012, 03:04 PM
Well it isn't quite a direct drop in but close enough
to make it worth the savings..
I used the Airex E2448 pump. But it says Walbro
right on the side of it.

Maximum Free Flow Rate (gph):
Maximum Pressure Range (psi):
Minimum Free Flow Rate (gph):
Minimum Pressure Range (psi):

This is what came in the box if you do this swap
you might want to get a new hose for it
New pump next to old (Walbro) it is smaller and has a smaller inlet
but the outlet is the same size
The pump in the Mustang braket. I trimmed the bottom of the carrier
so it would fit the way I wanted. Probably didn't need the ZipTies but
I wanted to make sure everything was secure and not going anywhere.

Overall it was an easy swap, no more difficult than a stock pump.
Took me about two hours. Biggest pain in the ass is putting the tank
back up by ones self, and mine was completely empty.
Sent the wife to the gas station to get 5 gallons of gas going to prime
the system and start here up..

09-22-2012, 03:54 PM
All u had to do is ask. Ida been happy to help

09-22-2012, 04:07 PM
Didn't think about it. I had the Ass so high in the air
my floor jack wouldn't go high enough. Now if I
had 4 arms working on the car would be a heck of
alot easier...

09-29-2012, 07:56 AM
Damn it I have to drop the tank again...
I have toi drop the tank again, am pretty
sure th hose connecting the pump to the
feed line cmae off or something... Yay!!!

09-29-2012, 09:57 AM
Need a hand? I have no plans today and i off work

09-29-2012, 03:46 PM
No I got it, ended up having to buy another fuelpump
because nobody sells the hose seperate. I jaked the car
up little put a box under the fuel tank, dropped it, and
jacked the car up far enough to get the pump out. Pretty
easy, to bad it was outside in the rain lol....